Fin & Rudder

Last Entry - 4/27/2008

Total Component Time: 35.0 hrs.

	Transformed the design into a full-scale drawing.		Started cutting gussets.
	I was finally able to start cutting some wood!		Counter-sunk the gussets.
	This time, I tried doing it differently.		Glued up the gussets on the Fin and Rudder.
	Removed the clamps, and checked the laminations.		Began sanding fin and rudder.
	Cut and layed out the remaining pieces of the fin and rudder.		Continued sanding fin and rudder.
	Glued the fin and rudder pieces together.		Started installing rudder hinges.
	Added filler blocks for the Trim Tab and Rudder Horn.		Finished installing rudder hinges.